CYBEX XP4010 Uživatelská příručka Strana 20

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 157
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 19
14
For Sun keyboard and mouse
1. Your user interface cables for these peripherals will be labeled either
CWSU-x or CWSUF-x , depending on the options you ordered. Use the
cable diagrams below to locate the correct cable.
2. At your secondary console, plug your Sun keyboard/mouse and VGA
monitor connectors into the two matching connectors on the user inter-
face cable.
If you have the CWSUF-x series cable, you will have three additional
connectors: two small connectors for a microphone and speakers, and a 9-
pin D-shaped serial connector for a serial port. The microphone connector
is denoted by a blue band around its cable. Plug your peripheral connec-
tors into the matching connectors on the user interface cable.
3. Attach the user interface cable to the unit by plugging the 62-pin connec-
tor into the rear of any available secondary console module. Ensure that
the connector is firmly seated, then tighten the thumbscrews.
NOTE: You may use your Sun monitor with an XP4000 Series unit if it will
function with all of your attached computers/workstations. See ‘Using Non-
multisync Monitors’ later in this chapter.
CWSU-
x
CABLE CWSUF-
x
CABLE
KEYBOARD/MOUSE
VGA VIDEO
KEYBOARD/
MOUSE
MICROPHONE
(blue band)
SPEAKERS
SERIAL PORT
VGA VIDEO
Zobrazit stránku 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 156 157

Komentáře k této Příručce

Žádné komentáře